Description
Repeatable dissolved ozone measurements.
The Ozone Analyzer is great for readings in low conductivity water with no interferences from oxidants or pH. Reagentless analysis of ozone - ion-selective membrane separates electrolyte from sample water. All-inclusive, pre-assembled panel reduces installation expense. Plug & play with digital controllers simplifies setup. Built-in flow regulation reduces need for additional accessories. Integral temperature sensor provides more accurate readings. Includes 2 years of typical maintenance parts. Ozone Analyzer includes: sc100 Universal Controller with RS-232 (MODBUS®) Communications, sc100 Universal Controller Mounting Panel.
Few Interferences from Oxidants or pH over a Wide Measurement Range
Bromine, chloramines, chlorine, chlorine dioxide, hydrogen peroxide, and pH do not interfere with ozone measurements using the Hach 9185sc Amperometric Ozone Sensor, which can measure from 0 to 2 mg/L ozone.
Ideal for Low-Conductivity Samples
The 9185sc ozone system has a low minimum detection limit of 0.005 mg/L ozone. Because the amperometric cell is separated from the sample by the membrane and is immerged into an electrolytic medium, the 9185sc ozone sensor is suitable for use in water with low conductivity.
Reliable Amperometric Measurements
The sensor used in the 9185sc system is a two-electrode amperometric sensor (gold cathode and silver anode) with a membrane selective to ozone. Membranes are pre-mounted on retaining caps to simplify and reduce maintenance time.
Flexible Options
Options available for the 9185sc ozone system include: Acidification Unit, which can be used intermittently or continuously for cleaning and is fully programmable, and Intermittent Flow Unit, which is fully programmable and saves resources while limiting excess flow to drain.
Easy Setup and Maintenance
The all-inclusive 9185sc ozone system comes pre-assembled on a panel. The membrane system of the sensor means there are no chemicals used for measurement. Maintenance is minimal and two years of typical maintenance items are included with the system.
Compatible with Hach Multi-Sensor, Multi-Parameter Digital Controllers
The Hach 9185sc Amperometric Ozone Sensor can be used with Hach’s new sc100 or sc1000 Digital Controllers. The sc100 controller accepts up to two sensors. The sc1000 accepts up to eight sensors. Multiple controllers can be networked to accommodate many more sensors and parameters, reducing the cost per measuring point. Just plug in any Hach “plug and play” digital sensor and it’s ready to use without software configuration. “Plug and play” connectivity means there’s no complicated wiring or set up. Network the 9185sc ozone sensor with any of Hach’s digital sensors for measuring dissolved oxygen, turbidity, ORP, conductivity, and many other parameters.
