Description
General description Device Configuration: Capsule T-line/Gauge Port: T-line Packaging Double Easy-Open bag Preparation Note Sterilization Method Gamma compatible to 40 kGy; 3 autoclave cycles of 60 min @ 123 °C; not in-line steam sterilizable This product was manufactured with a Millipore Express® membrane which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6). Analysis Note Bacterial Retention Samples of membrane used in this filter were quantitatively retentive of a minimum Brevundimonas diminuta challenge concentration of 1 x 10⁷ CFU/cm² using ASTM® F838 methodology. TOC/Conductivity After sterilization and a controlled water flush of 22 L, samples exhibited less than 500 ppb TOC per USP and less than 1.3 µS/cm per USP at 25 °C. Will meet the USP Oxidizable Substances Test requirements after a water flush of ≥3 L Other Notes Directions for Use Organism Retention: Microorganism Mode of Action: Filtration (size exclusion) Application: BioProcessing Intended Use: Reduction or removal of microorganism/bioburden Instructions for Use: Please refer wetting instructions of Filters with MILLIPORE EXPRESS® Membrane user guide Storage Statement: Please refer Filters with MILLIPORE EXPRESS® Membrane user guide Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations. These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices. Legal Information ASTM is a registered trademark of American Society for Testing and Materials MILLIPORE EXPRESS is a registered trademark of Merck KGaA, Darmstadt, Germany OPTICAP is a registered trademark of Merck KGaA, Darmstadt, Germany Disclaimer EMD Millipore Corporation certifies that this product complies with the European Pressure Equipment Directive, 97/23/EC of 29 May 1997. This product has been classified under Article 3 § 3 of the Pressure Vessel Directive. It has been designed and manufactured in accordance with sound engineering practice to ensure safe use. In compliance with Article 3 § 3 of this Pressure Vessel Directive, this product does not bear the CE mark.
